Thank you for choosing the MXO-RACING products, please read this document carefully before using it!

    The MX EVO RX-NB4 is an NB4-compatible ultra-miniature receiver for KYOSHO's MR-03EVO and MA-03EVO.

    In addition, we are developing miniature sensor brushless ESCs and other related products that can be directly mounted on this receiver.

Features：

Size: 13.5*10.0*3.5mm; 

Weight: 0.58g;

Compatible with FLYSKY AFHDS-A3 protoco;

Bind Operation:

    Install the MX EVO RX first, press the BIND switch and then turn on the power, release the BIND switch when the LED on the RX flashes quickly. Then proceed according to the BIND operation requirements of the transmitter. When the red LED on the RX changes from fast flashing to constant light, it means that the frequency binding is successful and the signal has been received.

    Finally, set up the transmitter according to the picture below. After setting, MX EVO RX-NB4 will output EVO signal.

How to set up the transmitter (when MX EVO RX is used on MR-03EVO/MA-03EVO):

   Because the brushless ESCs and servos on MR-03EVO/MA-03EVO cannot set the midpoint and end point, the user can only set the transmitter to adapt to the parameters of MR-03EVO/MA-03EVO. The settings are as follows:

1）TH TYPE  >  F5 : B5

2）EAP:  ST  >  L150%   R150%

             TH  >  H150%  B150%

3）D/R:  ST  >  100%   

             TH  >  100%

 Note: Points 2 and 3 can be adjusted according to user habits.

Please contact us if you have any feedback or suggestions, thank you!

Email: [email protected]  & [email protected]