MX transponder Personal ID Setting Method

       This document introduces how to modify the personal ID of MX Transponder related products. The operator should be as follows:

       1）Download GUI first, and then install the GUI software. If you have installed GUI software, please ignore this step;

       GUI download link: update.crossover-rx.com/mxo.zip;

       2）Prepare Tran ID NUM Changer and set the switch on the USB end to the position "I";

           

 

       3）Connect the USB end of the Trans ID NUM Changer on the PC. The other end is connected to the corresponding needle frame and connected to the product that needs to modify the personal ID number. As shown in the figure below:

Tran ID NUM CHANGER's needle is connected to MX Trans-01:

          

 

Tran ID NUM CHANGER's needle is connected to MX Trans-02, MX-GY201-T or MX-GY301-T:

         

    Note: 

       * The large -volume needle is a large needle, and this is LED on it. The small needle stand is a small needle frame with no LED on it.

       * Small needle frames are suitable for MX Trans-01, and large needle frames are suitable for MX Trans-02, MX-GY201-T and MX-GY301-T.

       * Before modifying the personal ID number of MX Trans-02, MX-GY201-T and MX-GY301-T, please disconnect the connection with Miniz first.

 

       4）Select the corresponding serial port on the GUI, and then click "Connect". At this time, the GUI display is as follows (the ID number displayed by each product is different):

       

 

       5）Change the ID MODE to "Custom", and then enter the ID number (ID range: 1 ~ 16777215) in Personal ID. As shown below:

    

       6）Then click the "Save" below GUI, when the "SuccessFully Save the Parameters" appears, it means that the personal ID number has been completed. As shown below:

 

       If the user is not satisfied with the personal ID number of this modified, then repeated the above operation. 

 

Please contact us if you have any feedback or suggestions, thank you!

Website: www.mxo-rc.com

Email: [email protected]  or  [email protected]